S T A T E O F N E W Y O R K
________________________________________________________________________
11680
I N A S S E M B L Y
September 2, 2026
___________
Introduced by COMMITTEE ON RULES -- (at request of M. of A. Simone) --
read once and referred to the Committee on Governmental Operations
AN ACT to amend the executive law, in relation to adopting standards of
the International code council for the design, fabrication and assem-
bly of factory manufactured homes, and in relation to third party
review of factory manufactured homes
THE PEOPLE OF THE STATE OF NEW YORK, REPRESENTED IN SENATE AND ASSEM-
BLY, DO ENACT AS FOLLOWS:
Section 1. Subdivision 2 of section 377 of the executive law, as added
by chapter 707 of the laws of 1981, paragraph a as amended by chapter
772 of the laws of 1986, is amended to read as follows:
2. The uniform fire prevention and building code shall:
a. provide reasonably uniform standards and requirements for
construction and construction materials for public and private build-
ings[, including factory manufactured homes,] consonant with accepted
standards of engineering and fire prevention practices;
b. formulate such standards and requirements, so far as may be practi-
cable, in terms of performance objectives, so as to make adequate
performance for the use intended the test of acceptability;
c. permit to the fullest extent feasible, use of modern technical
methods, devices and improvements which tend to reduce the cost of
construction without substantially affecting reasonable requirements for
the health, safety and security of the occupants or users of buildings;
d. encourage, so far as may be practicable, the standardization of
construction practices, methods, equipment, material and techniques;
[and]
e. ADOPT THE INTERNATIONAL CODE COUNCIL (ICC)/MBI 1200-2021 STANDARD
FOR OFF-SITE CONSTRUCTION: PLANNING, DESIGN, FABRICATION AND ASSEMBLY,
ICC/MBI 1205-2021 STANDARD FOR OFF-SITE CONSTRUCTION, AND ICC/MBI 1210-
2023 STANDARD FOR MECHANICAL, ELECTRICAL, PLUMBING SYSTEMS, ENERGY EFFI-
CIENCY AND WATER CONSERVATION IN OFF-SITE CONSTRUCTION: INSPECTION AND
REGULATORY COMPLIANCE; AND
F. eliminate restrictive, obsolete, conflicting and unnecessary build-
ing regulations and requirements which tend to increase unnecessarily
EXPLANATION--Matter in ITALICS (underscored) is new; matter in brackets
[ ] is old law to be omitted.
LBD16140-02-6
A. 11680 2
construction costs or retard unnecessarily the use of new materials, or
provide unwarranted preferential treatment to types or classes of mate-
rial or products or methods of construction.
§ 2. Paragraph c of subdivision 1 of section 383 of the executive law,
as amended by chapter 772 of the laws of 1986, is amended to read as
follows:
c. That, in cities with a population of over one million, the existing
building and fire prevention codes shall continue in full force and
effect beyond January one, nineteen hundred eighty-four unless the coun-
cil, after analysis and consultation with the building and fire offi-
cials of such cities, shall determine that said local code provisions
are less stringent than the uniform code. Existing local statutory,
regulatory and administrative laws and provisions of such cities shall
continue in full force and effect unless the foregoing is determined by
the council. Notwithstanding this paragraph, when such factory manufac-
tured homes are intended for use as one or two family dwelling units or
multiple dwellings of not more than two stories in height, provided such
multiple dwellings are not intended for use as hotels or motels, the
[provisions of this article and of the uniform fire prevention and
building code] INTERNATIONAL CODE COUNCIL (ICC)/MBI 1200-2021 STANDARD
FOR OFF-SITE CONSTRUCTION: PLANNING, DESIGN, FABRICATION AND ASSEMBLY,
ICC/MBI 1205-2021 STANDARD FOR OFF-SITE CONSTRUCTION, AND ICC/MBI 1210-
2023 STANDARD FOR MECHANICAL, ELECTRICAL, PLUMBING SYSTEMS, ENERGY EFFI-
CIENCY AND WATER CONSERVATION IN OFF-SITE CONSTRUCTION: INSPECTION AND
REGULATORY COMPLIANCE pertaining to factory manufactured homes shall
supersede any other provision of general, special or local law, ordi-
nance, administrative code, rule or regulation inconsistent or in
conflict therewith.
§ 3. Paragraph g of subdivision 1 of section 381 of the executive law,
as amended by chapter 560 of the laws of 2010, is amended to read as
follows:
g. procedures for inspection of certain classes of buildings based
upon design, construction, ownership, occupancy or use, including, but
not limited to, mobile homes, factory manufactured homes and state-owned
buildings; PROVIDED THAT ANY PLANS OR SPECIFICATIONS OF FACTORY MANUFAC-
TURED HOMES WHICH ARE IN COMPLIANCE WITH THE STANDARDS ADOPTED BY THE
INTERNATIONAL CODE COUNCIL PURSUANT TO PARAGRAPH E OF SUBDIVISION TWO OF
SECTION THREE HUNDRED SEVENTY-SEVEN OF THIS ARTICLE SHALL BE APPROVED BY
UNIT SERIAL NUMBER AND MAY BE USED IN SUBSEQUENT DEVELOPMENT PROJECTS
PURSUANT TO THIS SUBDIVISION PROVIDED THAT NO MODIFICATION HAS BEEN MADE
TO THE BUILDING STANDARDS RELATING TO FACTORY MANUFACTURED HOMES PURSU-
ANT TO ARTICLE THREE HUNDRED EIGHTY-ONE-A OF THIS ARTICLE SINCE THE PLAN
OR SPECIFICATION RECEIVED ITS INITIAL APPROVAL,
§ 4. The executive law is amended by adding a new section 381-a to
read as follows:
§ 381-A. THIRD PARTY REVIEW OF FACTORY MANUFACTURED HOMES. 1. (A) THE
DEPARTMENT SHALL PROVIDE BY REGULATION FOR QUALIFICATION AND DISQUALI-
FICATION OF DESIGN APPROVAL AGENCIES TO PERFORM APPROVAL OF FACTORY
MANUFACTURED HOMES AND FACTORY MANUFACTURED DEVELOPMENT PLANS AND SPEC-
IFICATIONS. THE APPROVALS OF SUCH DESIGN APPROVAL AGENCIES SHALL BE
DEEMED THE EQUIVALENT OF DEPARTMENT APPROVAL. THE REGULATIONS FOR QUALI-
FICATION OF DESIGN APPROVAL AGENCIES SHALL SPECIFICALLY PROVIDE FOR THE
ABSENCE OF ANY CONFLICT OF INTEREST BETWEEN MANUFACTURERS AND DESIGN
APPROVAL AGENCIES AND FOR DEPARTMENT OVERSIGHT OF DESIGN APPROVAL AGENCY
PERFORMANCE THROUGH AN AUDIT PROCESS.
A. 11680 3
(B) AN ARCHITECT LICENSED PURSUANT TO ARTICLE ONE HUNDRED FORTY-FIVE
OR ONE HUNDRED FORTY-SEVEN OF THE EDUCATION LAW MAY PERFORM APPROVAL OF
FACTORY MANUFACTURED HOUSING AND FACTORY MANUFACTURED DEVELOPMENT PLANS
AND SPECIFICATIONS UNDER PENALTY OF PERJURY. APPROVALS BY AN ENGINEER OR
ARCHITECT LICENSED IN THIS STATE SHALL BE DEEMED THE EQUIVALENT OF
DEPARTMENT APPROVAL. THE DEPARTMENT SHALL PROVIDE BY REGULATION FOR THE
QUALIFICATION OF ENGINEERS AND ARCHITECTS FOR THIS PURPOSE.
2. (A) THE DEPARTMENT SHALL ENFORCE AND INSPECT THE INSTALLATION OF
FACTORY MANUFACTURED HOMES. THE DEPARTMENT SHALL PROVIDE BY REGULATION
FOR THE QUALIFICATION AND DISQUALIFICATION OF INSTALLATION INSPECTION
AGENCIES TO PERFORM INSPECTIONS OF THE INSTALLATION OF FACTORY MANUFAC-
TURED HOMES AND THE CONSTRUCTION OF FACTORY MANUFACTURED DEVELOPMENTS.
THE INSTALLATION OF FACTORY MANUFACTURED HOMES AND THE CONSTRUCTION OF
FACTORY MANUFACTURED DEVELOPMENTS SHALL BE CONDUCTED IN ACCORDANCE WITH
THE REQUIREMENTS OF THE BUILDING STANDARDS PUBLISHED IN THE NEW YORK
STATE UNIFORM FIRE PREVENTION AND BUILDING CODE RELATING TO FACTORY
MANUFACTURED HOMES.
(B) ANY PLANS OR SPECIFICATIONS OF FACTORY MANUFACTURED HOMES APPROVED
BY THE DEPARTMENT PURSUANT TO THIS SECTION SHALL BE APPROVED BY UNIT
SERIAL NUMBER AND MAY BE USED IN SUBSEQUENT DEVELOPMENT PROJECTS PURSU-
ANT TO THIS SUBDIVISION PROVIDED THAT NO MODIFICATION HAS BEEN MADE TO
THE BUILDING STANDARDS RELATING TO FACTORY MANUFACTURED HOMES ADOPTED
PURSUANT TO THIS ARTICLE SINCE THE PLAN OR SPECIFICATION RECEIVED ITS
INITIAL APPROVAL.
3. (A) LOCAL USE ZONING REQUIREMENTS, LOCAL SNOW LOAD REQUIREMENTS,
LOCAL WIND PRESSURE REQUIREMENTS, LOCAL FIRE ZONES, BUILDING SETBACKS,
SIDE AND REAR YARD REQUIREMENTS, SITE DEVELOPMENT AND PROPERTY LINE
REQUIREMENTS, AS WELL AS THE REVIEW AND REGULATION OF ARCHITECTURAL AND
AESTHETIC REQUIREMENTS ARE SPECIFICALLY AND ENTIRELY RESERVED TO LOCAL
JURISDICTIONS NOTWITHSTANDING ANY REQUIREMENT OF THIS SECTION.
(B) LOCAL REQUIREMENTS IMPOSED ON FACTORY MANUFACTURED HOMES OR FACTO-
RY MANUFACTURED DEVELOPMENTS PURSUANT TO THE AUTHORITY GRANTED BY THIS
SECTION SHALL NOT VARY SUBSTANTIALLY FROM THE REQUIREMENTS IMPOSED ON
OTHER RESIDENTIAL BUILDINGS OF SIMILAR SIZE.
4. THE DEPARTMENT SHALL HEAR APPEALS BROUGHT BY ANY PERSON REGARDING
THE APPLICATION TO THAT PERSON OF ANY BUILDING STANDARD PUBLISHED IN THE
NEW YORK STATE UNIFORM FIRE PREVENTION AND BUILDING CODE RELATING TO
FACTORY MANUFACTURED HOMES OR FACTORY MANUFACTURED DEVELOPMENTS OR TO
ANY OTHER RULE OR REGULATION OF THE DEPARTMENT PROMULGATED PURSUANT TO
THIS ARTICLE.
§ 5. Subdivision 2 of section 382 of the executive law, as amended by
chapter 571 of the laws of 2021, is amended and a new subdivision 2-a is
added to read as follows:
2. Any person, having been served, either personally or by registered
or certified mail, with an order to remedy any condition found to exist
in, on, or about any building in violation of the uniform fire
prevention and building code, who shall fail to comply with such order
within the time fixed by the regulations promulgated by the secretary
pursuant to subdivision one of section three hundred eighty-one of this
article, such time period to be stated in the order, and any owner,
builder, architect, tenant, contractor, subcontractor, construction
superintendent or their agents or any other person taking part or
assisting in the construction of any building who shall knowingly
violate any of the applicable provisions of the uniform code or any
lawful order of a local government, a county or the secretary made ther-
eunder regarding standards for construction, maintenance, or fire
A. 11680 4
protection equipment and systems, shall be [punishable by a fine of not
more than one thousand dollars per day of violation, or imprisonment not
exceeding one year, or both for the first one hundred eighty days, and
for the following one hundred eighty days shall be punishable by a fine
of no less than twenty-five dollars and not more than one thousand
dollars per day of violation or imprisonment not exceeding one year, or
both and thereafter shall be punishable by a fine of no less than fifty
dollars and not more than one thousand dollars per day of violation or
imprisonment not exceeding one year, or both] GUILTY OF A MISDEMEANOR,
PUNISHABLE BY A FINE NOT EXCEEDING ONE THOUSAND DOLLARS OR BY IMPRISON-
MENT NOT EXCEEDING THIRTY DAYS, OR BY BOTH SUCH FINE AND IMPRISONMENT.
2-A. (A) FOR VIOLATIONS OF SECTION THREE HUNDRED EIGHTY-ONE-A OF THIS
ARTICLE, THE DEPARTMENT SHALL ASSESS CIVIL PENALTIES OF AT LEAST TWO
HUNDRED FIFTY DOLLARS BUT NO MORE THAN TWO THOUSAND DOLLARS. WHEN DETER-
MINING THE AMOUNT OF THE CIVIL PENALTY, THE DEPARTMENT SHALL TAKE INTO
CONSIDERATION WHETHER ONE OR MORE OF THE FOLLOWING OR SIMILAR CIRCUM-
STANCES APPLY:
(I) THE CITATION INCLUDES MULTIPLE VIOLATIONS;
(II) THE CITED PERSON HAS A HISTORY OF VIOLATIONS OF THE SAME OR SIMI-
LAR PROVISIONS OF THIS ARTICLE AND THE REGULATIONS PROMULGATED UNDER
THIS ARTICLE;
(III) IN THE JUDGMENT OF THE DEPARTMENT, THE PERSON HAS EXHIBITED BAD
FAITH OR A CONFLICT OF INTEREST;
(IV) IN THE JUDGMENT OF THE DEPARTMENT, THE VIOLATION IS SERIOUS OR
HARMFUL;
(V) THE CITATION INVOLVES A VIOLATION PERPETRATED AGAINST A SENIOR
CITIZEN, VETERAN, OR PERSON WITH DISABILITIES; AND
(VI) THERE IS EXCULPATORY EVIDENCE THAT, IN THE JUDGMENT OF THE
DEPARTMENT, IS MATERIAL TO THE ELEMENTS OF THE CURRENT VIOLATION FOR
WHICH THE CITATION IS BEING ISSUED AND IS SIGNIFICANTLY RELATED TO THE
DEGREE OF FAULT.
(B) IF A CITATION LISTS MORE THAN ONE VIOLATION AND EACH OF THE
VIOLATIONS RELATES TO THE SAME MANUFACTURING FACILITY OR CLIENT, THE
TOTAL PENALTY ASSESSMENT IN EACH CITATION SHALL NOT EXCEED TEN THOUSAND
DOLLARS.
(C) IF A CITATION LISTS MORE THAN ONE VIOLATION, THE AMOUNT OF
ASSESSED CIVIL PENALTY SHALL BE STATED SEPARATELY FOR EACH VIOLATION.
§ 6. This act shall take effect on the ninetieth day after it shall
have become a law.